8mm Forum


  
my profile | my password | search | faq | register | forum home
  next oldest topic   next newest topic
» 8mm Forum   » 8mm Forum   » B&H Model 1615 Help Needed

 - UBBFriend: Email this page to someone!    
Author Topic: B&H Model 1615 Help Needed
Tom Culver
Junior
Posts: 1
From: Chicago, IL, USA
Registered: Mar 2019


 - posted March 27, 2019 08:03 PM      Profile for Tom Culver     Send New Private Message       Edit/Delete Post 
I have a Bell & Howell Film projector (model 1615) than hasn't run in a while. It appears that the belt has loosened over time. I checked on line and there are a few videos that show how to take one off, but are not the same model. With this particular model it appears that the drive shaft from the motor goes right through the belt and that there is no way to get it off with disassembling part of the shaft at some point. I will be interested in ordering a replacement belt as well once I figure out how to get the old one off. Thanks for any input. I am mildly 'handy' and hoping it's not too much of a job to replace the belt.

--------------------
Tom

 |  IP: Logged



All times are Central  
   Close Topic    Move Topic    Delete Topic    next oldest topic   next newest topic
 - Printer-friendly view of this topic
Hop To:

Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation
UBB.classicTM 6.3.1.2