Posts: 715
From: Campobasso, Italy
Registered: Jun 2013
posted June 05, 2018 02:41 PM
Someone have the Erno RE-904 NF or the equivalent Goko RM 8008 and have changed to it the light bulb with a more powerful? I have always considered this editor a unique jewel, but the brightness and the definition never fully satisfied me. Basically it has a 6V 10W BA15s bulb, but I have not found suggestions for the change with an equivalent halogen, as happens for other editors: maybe it could damage the film? Thank you.
Posts: 373
From: Barendrecht, The Netherlands
Registered: Aug 2017
posted June 06, 2018 08:25 AM
I have a differend halogeenlamp in my MM1, but when the unit gets hot after a minute of 3 the light shuts off for a while. So you can use it for searching, but you need to shut off the lamp everytime you don't need it. You can forget about watching a whole film with the electric drive
Posts: 715
From: Campobasso, Italy
Registered: Jun 2013
posted June 07, 2018 01:04 PM
Thank you all. I'm looking for a LED replacement. On two editors that I have, I have halogen, but only because the replacement was recommended by some laboratory. On a 9.5mm projector I have a LED (cold light), not bad as a result ...