8mm Forum


  
my profile | my password | search | faq | register | forum home
  next oldest topic   next newest topic
» 8mm Forum   » 8mm Forum   » Belt change

 - UBBFriend: Email this page to someone!    
Author Topic: Belt change
Garvan Murphy
Junior
Posts: 2
From: Dublin, Ireland
Registered: Feb 2019


 - posted February 13, 2019 06:07 AM      Profile for Garvan Murphy   Email Garvan Murphy   Send New Private Message       Edit/Delete Post 
Can anybody help with how to change the belt on a EMUG Mark 605D

Thanks in anticipation

 |  IP: Logged

Lee Mannering
Film God

Posts: 3216
From: The Projection Box
Registered: Nov 2006


 - posted February 13, 2019 07:18 AM      Profile for Lee Mannering     Send New Private Message       Edit/Delete Post 
Greetings to Ireland!

It should be the same as the 610D. Set main control to neutral, don't connect the mains.

Remove back cover remove old belt and slip the new one over bigger top drive wheel then onto smaller one below.

Screw back on again job done.

 |  IP: Logged

Garvan Murphy
Junior
Posts: 2
From: Dublin, Ireland
Registered: Feb 2019


 - posted February 18, 2019 06:25 AM      Profile for Garvan Murphy   Email Garvan Murphy   Send New Private Message       Edit/Delete Post 
Thanks a million

 |  IP: Logged



All times are Central  
   Close Topic    Move Topic    Delete Topic    next oldest topic   next newest topic
 - Printer-friendly view of this topic
Hop To:

Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation
UBB.classicTM 6.3.1.2