8mm Forum


Post New Topic  Post A Reply
my profile | my password | register | search | faq | register | forum home
  next oldest topic   next newest topic
» 8mm Forum   » 8mm Forum   » DISTANT DRUMS walton 3x or 4x 400 ?

 - UBBFriend: Email this page to someone!    
Author Topic: DISTANT DRUMS walton 3x or 4x 400 ?
Jason Moffatt
Film Handler

Posts: 87
From: Denham, Buckinghamshire, UK
Registered: Aug 2014


 - posted February 24, 2019 12:14 PM      Profile for Jason Moffatt   Email Jason Moffatt   Send New Private Message       Edit/Delete Post 
Hi all, is the gary cooper film “distant drums” released by walton a 3x 400ft or 4 x 400ft as there is a 3x on ebay, i always thought it was 4x ?.

 |  IP: Logged

Tom Photiou
Film God

Posts: 4772
From: Plymouth U.K
Registered: Dec 2003


 - posted February 25, 2019 04:34 PM      Profile for Tom Photiou   Email Tom Photiou   Send New Private Message       Edit/Delete Post 
ours is 4 x 400

 |  IP: Logged

Chip Gelmini
Phenomenal Film Handler

Posts: 1659
From: Brooksville, FL
Registered: Jun 2003


 - posted February 27, 2019 10:09 AM      Profile for Chip Gelmini   Email Chip Gelmini   Send New Private Message       Edit/Delete Post 
Jason

If you recently purchased a used copy it should be inspected. If it was released on 4 x 400 - you'll find the original splices.

Here's what happens in theory

The print goes out brand new from the lab on 4 x 4.

At some point the leads are cut and big reels are used.

During the big reel assembly, care is not taken to mark the joins for later break down back to original reels.

When the film is broken down a few years later, reels are wound until they are full, and a new cut is made.

Somewhere within those new cuts are the original big reel joins.

If you can locate those joins, it is possible to reassemble the print to the original 4 x 4 release.

When you find a splice you should be within 400 feet on a per reel basis although that is not always the case. When this happens one thing to look for is between both sides of the splice there is almost always a scene change or jump cut.

It is extremely rare although possible for a reel change to occur with no change of camera angle.

If you are reformatting an optical film you can check the optical track at the splice. A few inches before the splice the track will be silent and show NO signs of movement. As the splice passes then the movement begins of active sound.

Consider this information if you are looking to restore the print to the original 4 x 400 release. And then you will have the reels you are looking for.

If all of that sounds confusing it isn't. Just make sure you have a pair of hand crank rewinds to use for this job.

Chip Gelmini

 |  IP: Logged



All times are Central  
Post New Topic  Post A Reply Close Topic    Move Topic    Delete Topic    next oldest topic   next newest topic
 - Printer-friendly view of this topic
Hop To:

Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation
UBB.classicTM 6.3.1.2