8mm Forum


Post New Topic  Post A Reply
my profile | my password | register | search | faq | register | forum home
  next oldest topic   next newest topic
» 8mm Forum   » General Yak   » Continental 2-pin Plug

 - UBBFriend: Email this page to someone!    
Author Topic: Continental 2-pin Plug
Maurice Leakey
Film God

Posts: 5452
From: Bristol. United Kingdom
Registered: Oct 2007


 - posted January 10, 2019 04:11 AM      Profile for Maurice Leakey   Email Maurice Leakey   Send New Private Message       Edit/Delete Post 
Here is a warning.

I bought a Super 8 projector from a European seller which arrived with its "kettle lead" terminating in a plastic 2-pin plug.
I got a UK 3-pin plug ready with appropriate tools to make the change as I assumed the lead itself would have three cores.
But I was wrong. [Embarrassed] The lead only had two cores.

Another warning.

Another thing to check is the voltage selector before you plug into UK mains. I knew from photographs that the projector was multi voltage. It was necessary to partially remove the back to pull out the voltage selector, which was set to 220 volts, and re-insert it into the 240 volt setting.
I used the word "partially" when referring to the back. This was because often the speaker lead/s is/are very short and terminate with plugs. Most plugs and wiring have been in situ now for about 40 years and may not take kindly to being removed, or more worse, pins break off. In my case I gently pulled the back only a sufficient way to change the voltage setting.

--------------------
Maurice

 |  IP: Logged



All times are Central  
Post New Topic  Post A Reply Close Topic    Move Topic    Delete Topic    next oldest topic   next newest topic
 - Printer-friendly view of this topic
Hop To:

Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2010 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation
UBB.classicTM 6.3.1.2