This is topic GS1200 Speed board...where is it? in forum 8mm Forum at 8mm Forum.


To visit this topic, use this URL:
https://8mmforum.film-tech.com/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=000817

Posted by Alan Rik (Member # 73) on October 17, 2004, 11:46 AM:
 
Hi guys!
I have got one of Pedro's synch units and all is well with 18fps but on 24fps the ESS needle goes crazy. He suggested that my setting for the 24fps switch may need adjusting. So I went and opened up the rear cover. I couldn't find the board!
I know on the ST180 and the GS800 It was easy to find but on this im lost. Is it possible that it wasn't included on my machine? Hmm..

 -
 
Posted by Kevin Faulkner (Member # 6) on October 17, 2004, 12:24 PM:
 
Hi Alan,
That board at the bottom of your picture is the speed control board.

The Right hand pot is for 24FPS and the left 18fps.

Set your machine up as normal ie with the ESS switch in the normal position and then plug in pedros unit with the speed control set to 24fps on his unit and the projector. With the projectors speed control set to the centre position adjust the speed control pot on the board in the back until the needle is as stable as possible. Voila!!! job done.

Email me direct if your want any more info.

Kev [Smile]
 


Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation
UBB.classicTM 6.3.1.2