This is topic Is there a camera that disengange the built in filter automatically? in forum 8mm Forum at 8mm Forum.


To visit this topic, use this URL:
https://8mmforum.film-tech.com/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=008065

Posted by Winbert Hutahaean (Member # 58) on April 04, 2013, 04:25 PM:
 
I don't know if I were lucky.

I was shooting with Sankyo XL-40S using Ektachrome 100D.

Since that was a daylight stock I should switch the filter from tungsten to daylight but just realized it in the middle of shooting, so I switched it later on.

I was thinking that the first half of shooting would be terrible color due to forget switching the filter.

But when the film arrived from lab, I checked that the picture on the beginning had no different with the other half.

So is there a camera that automatically engage or disengage the filter depending on the notch made on the cartridge?

thanks
 
Posted by Maurizio Di Cintio (Member # 144) on April 04, 2013, 07:34 PM:
 
Well most cameras are fitted with an auto filter override system: it consists of a little pin placed towards the bottom of the camera chamber (same side as where the film speed pins are located, only lower). If the cartridge is properly notched (i.e. there is no notch) the cartridge iteself will rule out the filter. But not all cameras are equipped with such a system. Yours, apparently, is.
 


Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation
UBB.classicTM 6.3.1.2