This is topic Eumig 940 in forum 8mm Forum at 8mm Forum.


To visit this topic, use this URL:
https://8mmforum.film-tech.com/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=012301

Posted by Stuart Hilliker (Member # 737) on May 19, 2018, 07:20 AM:
 
I’m looking for four fader caps to replace those missing from my Eumig 940.
Does anyone have any spares?
Thanks
 
Posted by Steve Klare (Member # 12) on May 19, 2018, 07:23 AM:
 
If anybody can define the capacitances, types and voltages of the caps, they can probably be bought new. (Eumig often put schematics in their manuals.)
 
Posted by Stuart Hilliker (Member # 737) on May 19, 2018, 07:28 AM:
 
Sorry Steve. I should have been clearer. It’s the plastic tops of the faders I’m looking for, not capacitors for a change! They appear to snap off very easily.
 
Posted by Steve Klare (Member # 12) on May 19, 2018, 07:33 AM:
 
Sorry!

-you say "cap" around an electronics guy and it gets the Microfarads happening! [Big Grin]
 
Posted by Maurice Leakey (Member # 916) on May 19, 2018, 07:55 AM:
 
A project for Edwin perhaps?
 
Posted by Martin Dew (Member # 5748) on May 21, 2018, 05:27 PM:
 
I know where you can get some slider caps, Stuart. PM if you're interested in the manual too.
 
Posted by Stuart Hilliker (Member # 737) on May 22, 2018, 12:36 AM:
 
Thanks Martin. Have sent you an email.
 


Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation
UBB.classicTM 6.3.1.2