This is topic Belt change in forum 8mm Forum at 8mm Forum.

To visit this topic, use this URL:;f=1;t=012774

Posted by Garvan Murphy (Member # 6856) on February 13, 2019, 06:07 AM:
Can anybody help with how to change the belt on a EMUG Mark 605D

Thanks in anticipation
Posted by Lee Mannering (Member # 728) on February 13, 2019, 07:18 AM:
Greetings to Ireland!

It should be the same as the 610D. Set main control to neutral, don't connect the mains.

Remove back cover remove old belt and slip the new one over bigger top drive wheel then onto smaller one below.

Screw back on again job done.
Posted by Garvan Murphy (Member # 6856) on February 18, 2019, 06:25 AM:
Thanks a million

Visit for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation