This is topic B&H Model 1615 Help Needed in forum 8mm Forum at 8mm Forum.


To visit this topic, use this URL:
https://8mmforum.film-tech.com/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=012868

Posted by Tom Culver (Member # 6918) on March 27, 2019, 08:03 PM:
 
I have a Bell & Howell Film projector (model 1615) than hasn't run in a while. It appears that the belt has loosened over time. I checked on line and there are a few videos that show how to take one off, but are not the same model. With this particular model it appears that the drive shaft from the motor goes right through the belt and that there is no way to get it off with disassembling part of the shaft at some point. I will be interested in ordering a replacement belt as well once I figure out how to get the old one off. Thanks for any input. I am mildly 'handy' and hoping it's not too much of a job to replace the belt.
 


Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation
UBB.classicTM 6.3.1.2