8mm Forum: Singer Instaload 16 Model/Product

This is topic Singer Instaload 16 Model/Product - 2120 in forum 16mm Forum at 8mm Forum.

To visit this topic, use this URL:
https://8mmforum.film-tech.com/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=5;t=000611

Posted by Joe Padavic (Member # 2412) on January 22, 2011, 08:40 AM:

I am in need of the "circuit board" that is mounted upright for this 16mm Singer Instaload. Any assistance would be appreciated. Thanks, Joe.

Posted by Richard C Patchett (Member # 974) on January 22, 2011, 07:20 PM:

Greetings Joe
Need to know the model number of this projector and any markings on the board.
I may have one that is rebuild $60.00 plus mailing
Contact me at patchetts@ameritech.net
Whats wrong with yours?

Posted by Joe Padavic (Member # 2412) on January 22, 2011, 09:04 PM:

I believe it is a model/product # is 2120.
Neither the lamp nor the audio lamp work. As best as I can remember the local camera repair shop says the pre-amp board is blown. Without pulling the board the only markings I can read is is "3ASB" stamped on the back side of the board.

Posted by Jim Schrader (Member # 9) on January 23, 2011, 05:26 PM:

do those have fuses?

Posted by Joe Padavic (Member # 2412) on January 24, 2011, 08:42 AM:

Looks like there is one on the lower left of the board. It looks good.

Posted by Winbert Hutahaean (Member # 58) on January 24, 2011, 09:59 AM:

A little bit off topic...

Since I am not into 16mm and just found this brand only available in 16mm format....is Singer 16mm is THE SAME company with Singer Sewing Machine?

thanks

Posted by Joe Padavic (Member # 2412) on January 24, 2011, 11:21 AM:

Originally produced by Graflex, which in later years was acquired by General Precision Equipment Company. Then Singer bought GPE in 1968.

UBB.classic^TM 6.3.1.2