8mm Forum


  
my profile | my password | search | faq | register | forum home
  next oldest topic   next newest topic
» 8mm Forum   » 8mm Forum   » Bolex 18-5: Broken film guide/height-control spindle

 - UBBFriend: Email this page to someone!    
Author Topic: Bolex 18-5: Broken film guide/height-control spindle
Zach Von Joo
Film Handler

Posts: 33
From: San Francisco
Registered: Sep 2010


 - posted September 06, 2012 10:23 AM      Profile for Zach Von Joo   Email Zach Von Joo   Send New Private Message       Edit/Delete Post 
The plastic spindle that helps to guide the film which is also used to correct the projector height has broken off.

Any suggestions as to what sort of epoxy to use for this?

I tried taking the spindle out from the inside to get a close look at it but the screws holding the plastic plate protecting the spindle from the back are really stuck.

Thanks!

 |  IP: Logged

Pasquale DAlessio
Film God

Posts: 3523
From: Bristol,RI, USA
Registered: May 2010


 - posted September 06, 2012 11:45 AM      Profile for Pasquale DAlessio     Send New Private Message       Edit/Delete Post 
I use the 2 part 5 minute eboxy for my repairs and it works great [Wink]

 |  IP: Logged

Zach Von Joo
Film Handler

Posts: 33
From: San Francisco
Registered: Sep 2010


 - posted September 06, 2012 11:56 AM      Profile for Zach Von Joo   Email Zach Von Joo   Send New Private Message       Edit/Delete Post 
I'll give it a shot! Thanks, Pasquale.

 |  IP: Logged



All times are Central  
   Close Topic    Move Topic    Delete Topic    next oldest topic   next newest topic
 - Printer-friendly view of this topic
Hop To:

Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation
UBB.classicTM 6.3.1.2