Phil Mitchell
Expert Film Handler
Posts: 144
From: Melbourne, Australia
Registered: Aug 2013
|
posted October 28, 2014 04:38 AM
Hi all, rare chance most likely, but one never knows till one asks.
I am after the small power board from a Sankyo 600, (most likely also found in some Titan or other Sankyo machines if they have Micro switches) which sits on top of where Micro Switches are, MS connect to it and on other side the blue and white wires from motor also connect to it, a Green Capacitor has come off, in fact the two on it were very loose.
I suspect they control speed to motor in a ways running without it, motor goes fast so I didn't run it for more than a few seconds.
If no luck finding one, I will get some Caps ( Jaycar here in Aust sell them, Green one labelled 104 which I found out is 100 Nano Farads and replace the two of them, a little bit tricky as there is a resistor right next to hole for one of the Cap.
Refer picture.
Thanks
Phil
| IP: Logged
|
UBBFriend: Email this page to someone!
Printer-friendly view of this topic
