8mm Forum


  
my profile | my password | search | faq | register | forum home
  next oldest topic   next newest topic
» 8mm Forum   » 16mm Forum   » Siemens 2000 projector missing part

 - UBBFriend: Email this page to someone!    
Author Topic: Siemens 2000 projector missing part
Kurt Froberg
Junior
Posts: 18
From: Vasteras, Sweden
Registered: May 2017


 - posted September 10, 2019 04:28 AM      Profile for Kurt Froberg   Email Kurt Froberg   Send New Private Message       Edit/Delete Post 
Hi all, I´ve just acquired a Siemens 2000 16 mm sound projector in good working order. There´s only one part missing on it, the release knob for the lower sprocket wheel. It can be handled by manually pulling out the knob axis (with a pair of pliers) but it would be good if I could just find a suitable knob. The knob is springloaded and threaded on the axis so I was thinking of temporarily putting on an ordinary nut or locknut on the knob axis, but when I try with a M3 nut it will not fit. Could it perhaps be 1/8" thread on this part? But it´s a German machine...
There are two of theses knobs on the machine, but one is missing, see attached picture.
Any help would be appreciated.

Kurt

 -

 |  IP: Logged



All times are Central  
   Close Topic    Move Topic    Delete Topic    next oldest topic   next newest topic
 - Printer-friendly view of this topic
Hop To:

Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation
UBB.classicTM 6.3.1.2