8mm Forum: ST1200HD Belt Removal/Replace

»	8mm Forum » 8mm Forum » ST1200HD Belt Removal/Replace

UBBFriend: Email this page to someone!

Author

Topic: ST1200HD Belt Removal/Replace

Jim Schrader
Phenomenal Film Handler

Posts: 1628
From: Savage, MN, USA
Registered: Jun 2003

posted October 24, 2015 03:52 PM

I managed to get it off by tapping the lower pulley to the right to give me enough room to get it off.

--------------------
jim schrader
"Let's see “do I have that title already?"

| IP: Logged

Janice Glesser
Film Goddess

Posts: 3468
From: Sunnyvale, CA USA
Registered: Sep 2011

posted October 24, 2015 06:57 PM

Jim...That's the point I where I described was tight, but by stretching the belt and easing the pulley and shutter over...you can get it threw.

--------------------
Janice

"I'm having a very good day!"
Richard Dreyfuss - Let It Ride (1989).

| IP: Logged

Jim Schrader
Phenomenal Film Handler

Posts: 1628
From: Savage, MN, USA
Registered: Jun 2003

posted October 24, 2015 09:54 PM

I managed to get the belts on near the shutter I tapped on the pulley that is attached to the fan shaft and the pulley slid over 3/16" just enough to get the old belt off and the new thicker square belt, I also got the upper pulley assy. back on I'll have to take it to a guy here in Minneapolis who can fine tune it, it runs but not all the time, rewind the same the new belts are probably to blame.

--------------------
jim schrader
"Let's see “do I have that title already?"

| IP: Logged

All times are Central

Printer-friendly view of this topic

UBB.classic^TM 6.3.1.2