8mm Forum: ELF NT1 My breakdown

»	8mm Forum » 16mm Forum » ELF NT1 My breakdown

UBBFriend: Email this page to someone!

Author

Topic: ELF NT1 My breakdown

Tom Photiou
Film God

Posts: 4837
From: Plymouth U.K
Registered: Dec 2003

posted January 08, 2017 01:15 PM

I posted on the other channel about a little mishap which happened on Thursday night while finishing a film show with my NT1.
A quick phone call to Mr Parsons put my mind at rest and i know which way to go, Mr Dave Guest has kindly offered me a working NT1 which i can continue to use, A massive thank you to both of these Gents.
What i would like to do is just explain to you all what happened so hopefully i can obtain the necessary part to sort out my old faithful. What i intend to do now i have another working machine on the way is take the opportunity to take my oldy apart and give it a darn good once over to best of my ability. Should i cock it all up i at least have spares but hopefully all will turn out good.
The motor capacitor decided to blow, it leaked all over the place but i have to confess i switched the machine on to put the last 20/30 ft of film through so that was a stupid move on my behalf.This is what happened,

And this is the part i would like to get please

| IP: Logged

Kevin Clark
Jedi Master Film Handler

Posts: 978
From: Bapchild, Kent, UK
Registered: May 2004

posted January 08, 2017 05:51 PM

Hello Tom

I'm not suggesting for one moment this is exactly the one you need but AC motor start up capacitors all do more or less the same thing so this should suit:

http://www.ebay.co.uk/itm/Universal-Start-and-Run-Motor-Capacitor-4-7-8-12-5-16-20-25-UF-Pre-Wired-Cables-/231948530518?var=&hash=item360135b356:m:mOW2pyIYRDBRQYSxlcVNMlw

Let Bill know and I'm sure he will point you in the right direction for one or confirm this is OK. The physical measurements are important to match up too so it will fit in the original clamp. I changed one on my Fumeo a while back and it was an easy job to do.

I'm surprised you felt the need to buy another projector though as you have years of technical knowledge so I am sure you can get this projector working again.

Kevin

| IP: Logged

Tom Photiou
Film God

Posts: 4837
From: Plymouth U.K
Registered: Dec 2003

posted January 09, 2017 06:30 AM

Thanks Kevin, i will do that, the one thats coming is a good working NT1 so one or the other will be a bit of a hobby in dismantling and restoring. Always fancied having a go at this. Also been looking out for a 1200HD to do the same. The other NT1 coming is very low priced. [Wink]

I am also a bit worried that by keeping it going for a few minutes i may not have done the motor itself any good.

| IP: Logged

All times are Central

Printer-friendly view of this topic

UBB.classic^TM 6.3.1.2