This is topic Eumig S912 GL in forum 8mm Forum at 8mm Forum.
To visit this topic, use this URL:
https://8mmforum.film-tech.com/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=003748
Posted by Maurice Leakey (Member # 916) on May 30, 2008, 02:38 AM:
Does anyone know how to remove the lens assembly on this projector?
Posted by Michael Beyer (Member # 1143) on May 30, 2008, 02:47 AM:
Hi Maurice,
my english is not very good, so I hope you will understand me.
On my Eumig 934 I remove the lens as follow:
- Turn the knob against clockwise
- Press a little bit against the lens from the front
- Now turn the knob 1-2mm again against the clockwise
- Then you can take out the lens.
Regards,
Michael
P.S.: I hope you know what I mean
Posted by Maurice Leakey (Member # 916) on May 30, 2008, 04:06 AM:
Michael
Thank you. Your English is very good, however, I am not sure by your use of the word "against".
You say "Turn the knob against clockwise." I assume you mean "anti-clockwise". For example, the opposite way to clockwise.
Do I push the lens inwards? Towards the projector?
I assume to put the lens back into the projector all the above is done in reverse.
Your help is appreciated.
Posted by Michael Beyer (Member # 1143) on May 30, 2008, 04:12 AM:
Hi Maurice,
yes, I mean "anti-clockwise" the "Focus-knob".
The lens must be pushed towards the projector, but just a little bit !
And yes, the whole action in reverse to put it back.
Posted by Maurice Leakey (Member # 916) on May 30, 2008, 04:26 AM:
Michael
Thank you for clearing this up. You have been most helpful.
Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC
UBB.classicTM
6.3.1.2