This is topic Eumig 607D Question in forum 8mm Forum at 8mm Forum.


To visit this topic, use this URL:
https://8mmforum.film-tech.com/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=004664

---

Posted by William Walsh (Member # 1261) on July 05, 2009, 02:24 PM:
 
Greetings,

To save some time and gas does anyone know where I can purchase a plug for this unit? Any other adjustments I will need to make to use this projector?

Thanks,

Bill

Projector
 

---

Posted by Jon Addams (Member # 816) on July 05, 2009, 02:36 PM:
 
Hello Bill,

A cord to match the original plug is almost impossible to find these days. I suggest you remove the original plug and install a standard three-prong (computer-type) connector in its place.
You can find those anywhere and it’s not a difficult job.

Regarding any other adjustments to use the projector, it’s hard to tell, you may not need any. You should be able to know better once you run the projector.

Good luck

Jon
 

---

Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC


UBB.classic^TM 6.3.1.2