This is topic Adapting a 35mm Cinebug for 16mm? in forum 16mm Forum at 8mm Forum.
To visit this topic, use this URL:
https://8mmforum.film-tech.com/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=5;t=001954
Posted by Stuart Reid (Member # 1460) on March 21, 2019, 05:08 AM:
Hey all, do you think it would be possible to adapt a 35mm Cinebug to use it with 16mm? I think there's just one sprocket which could probably be 3d printed. Thoughts?
Posted by Maurice Leakey (Member # 916) on March 21, 2019, 11:21 AM:
I've never needed such an accessory as I've found that 16mm library prints repaired in such a way often shrink slightly over time, and the tape does not, thus causing running problems with some 16mm projectors.
For small perforation repairs the good old CIR is a suitable item to use.
Also, I'm not sure if 16mm repair tape is still available.
https://www.youtube.com/watch?v=lUsErgqo8L0
Posted by Stuart Reid (Member # 1460) on March 24, 2019, 03:52 PM:
Yes Maurice the tape is still available from Urbanski in the US.
Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC
UBB.classicTM
6.3.1.2