Tweet
Hi, I have an ST1200D that has had its shutter rubber taken off and the shutter edge cleaned up.
But when the clutch has been put back in or adjusted at the time, the rubber wheel has been set too hard against the shutter.
You can hear the motor strain building as you watch a film, if you press slightly the 24/18 switch down a little, it runs well, and the strain is off.
But I`ve never adjusted one of the clutches pressure against the shutter, so asking first before I try to any tips or ideas or what to do etc please to adjust it back slightly please.
Also while I am on, its not an issue as the claw sounds fine, but does anyone know how you grease the claw mechanism please, and with what.
Many Thanks Mark.
But when the clutch has been put back in or adjusted at the time, the rubber wheel has been set too hard against the shutter.
You can hear the motor strain building as you watch a film, if you press slightly the 24/18 switch down a little, it runs well, and the strain is off.
But I`ve never adjusted one of the clutches pressure against the shutter, so asking first before I try to any tips or ideas or what to do etc please to adjust it back slightly please.
Also while I am on, its not an issue as the claw sounds fine, but does anyone know how you grease the claw mechanism please, and with what.
Many Thanks Mark.