Tweet
Timing an Elmo pull down claw.
I have several Elmo ST-180 ETC projectors that I use to transfer to digital files. Over time the rubber roller at the end of the pull down claw wears down and the picture will start to jitter. I have a new pull down claw to replace the old one, and I think I can replace it. I'm wondering about timing the pull down claw with the shutter. How hard is this to do? Thanks!
- Welcome to the new 8mm Forum! The forum you are looking at is entirely new software. Because there was no good way to import all of the old archived data from the last 20 years on the old software, everyone will need to register for a new account to participate. To access the original forums from 2003-2019 which are now a "read only" status, click on the "FORUM ARCHIVE" link above. Please remember registering with your first and last REAL name is mandatory. This forum is for professionals and fake names are not permitted. To get to the registration page click here. Once the registration has been approved, you will be able to login via the link in the upper right corner of this page. Also, please remember while it is highly encouraged to upload an avatar image to your profile, is not a requirement. If you choose to upload an avatar image, please remember that it IS a requirement that the image must be a clear photo of your face. Thank you!