This is topic Bauer P7 manual requested in forum 16mm Forum at 8mm Forum.

To visit this topic, use this URL:;f=5;t=000692

Posted by Dave Cragg (Member # 401) on September 20, 2011, 11:21 AM:
Help! Does anyone have an English language manual for the Bauer P7 please?

I've downloaded an English manual for the P6 but as I'm a complete novice with regards to 16mm (just received my first 16mm projector yesterday)and I'm a bit confused; for automatic film threading does this still involve some manual threading as the P6 manual suggests?

Any help appreciated as always,
Posted by Alessandro Pavoni (Member # 1739) on September 20, 2011, 12:14 PM:
Hi Dave, I send you a PM.
Posted by Dave Cragg (Member # 401) on September 20, 2011, 02:37 PM:
Thanks Alessandro,
unfortunately I'm having problems getting it into a format that Google will recognise as text and translate.

I appreciate the effort though.

Posted by Robert Lewis (Member # 1458) on September 20, 2011, 04:08 PM:

I have two Bauer P7s, and I think you will find yours a very nice projector to work with. It auto-threads without assistance right up to the point where you need to lead the film on to the take-up reel.

To auto-thread, you must first push down the large green "button" which is situated over the gate. You must make sure that it fully locks down. Then switch on and feed the film into the first roller. The film will then thread its way through to the rear of the machine. Allow a good length of film to pass through and then, by hand. At this point switch off the projector. Then take the film up the back of the projector and loop it around the roller which is located at the top and then lead the film onto the take-up spool. As you tighten the film on the take-up spool pull it tight until you see and hear the "button" you pressed down when starting the process release itself and pop back up. You can then switch the projector on and show your film.

If you wish talk about these projectors, send me a private message with your phone number and I will happily call you. I am in the UK (Midlands).
Posted by Dave Cragg (Member # 401) on September 20, 2011, 04:25 PM:
Thanks Robert, I'll try that.

Posted by Dave Cragg (Member # 401) on September 25, 2011, 03:44 PM:
I now have a copy of the manual for this projector in English; If anyone would like a copy I'll scan it in and email it.

Although for the 'studio' version most of the controls and layout are the same.


Visit for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation