Chip Carpenter
Film Handler
Posts: 32
From: Newport News, VA, USA
Registered: Oct 2008
|
posted November 03, 2008 10:14 AM
Hi all -
I replaced a set of belts on my Elmo ST-1200HD (good ebay buy, but the belts were useless) and I want to be sure that I didn't make it harder than I needed to . . . (I got a copy of the service manual, but it doesn't cover belt changes.
The drive belts were simple enough, but the take up belt required that I remove the drive gear for the take up wheel. Relatively simple, once I realized it, just an allen wrench an a few minutes . . .
Is this the best way to make this change, or did I miss something obvious (happens more often than I care to admit!) ![[Big Grin]](biggrin.gif)
--------------------
Elmo ST-1200HD M with the Elmo 1.1 Lens and a Chinon 2500GL
| IP: Logged
|
UBBFriend: Email this page to someone!
Printer-friendly view of this topic
