8mm Forum: Problem with Eumig 810D

»	8mm Forum » 8mm Forum » Problem with Eumig 810D

UBBFriend: Email this page to someone!

Author

Topic: Problem with Eumig 810D

Carlos Paz
Junior
Posts: 17
From: Madrid, Madrid, Spain
Registered: Jan 2010

posted February 02, 2011 07:08 AM

Hello Friends,

I have recently discover a problem with my new proyector Eumig 810d. I note that the speed it's a bit higher than the normal. You can see it, in the sound films, where the voices sounds like more high-pitched than normal. (Darth Vader voice is horrible...).

Can you help me? Where should be the problem?

Thanks a lot

Carlos

| IP: Logged

frank arnstein
Jedi Master Film Handler

Posts: 534
From: Gold Coast. Australia
Registered: Jan 2005

posted February 02, 2011 02:42 PM

Hi Carlos
Remove the back cover & see if the A/C line frequency switch is set to the right position for your local power supply.
Its either 50hz or 60hz & you will see the switch near the speed adjustment sliding drive pinion. The switch sets the correct position on the disc for the driving pinion.
Needs to run at the correct sound speed of 24fps. Sounds like you may have it set to the wrong position. Move the switch over & see if the speed corrects itself.

dogtor frankarnstein [Wink]

--------------------
At Projector Heaven the Focus is always on Detail.

____
[o:/o]<|=- dogtor@projectorheaven.com.au
//``\\
-----------------------------------------------

| IP: Logged

Carlos Paz
Junior
Posts: 17
From: Madrid, Madrid, Spain
Registered: Jan 2010

posted February 03, 2011 10:06 AM

Finally, I have say goodby to the projector (I give it to his old owner). I tried changing waht you said, but the speed is almost the same, so I prefer go now to a better projector...

| IP: Logged

All times are Central

Printer-friendly view of this topic

UBB.classic^TM 6.3.1.2