8mm Forum: Sankyo 700

»	8mm Forum » 8mm Forum » Sankyo 700

UBBFriend: Email this page to someone!

Author

Topic: Sankyo 700

Kenneth Vahrenkamp
Junior
Posts: 6
From: Allen, TX, USA
Registered: Sep 2015

posted September 05, 2015 08:08 AM

Where is the sound head located? I would try to clean it if I knew that. I am new to this forum.

| IP: Logged

Maurizio Di Cintio
Jedi Master Film Handler

Posts: 977
From: Ortona, Italy
Registered: Jan 2004

posted September 05, 2015 08:40 AM

It's right below the lamp housing: you will see some wirings soldered to the terminals (some reds, some whites etc). The head is incased in an assembly which holds it in place with the right adjustment micro-screws. The gaps are accessible with the machine in stop mode: the pressers unit, i.e. a shoe encompassing 4 pressers for the sound head, will sit detached from the head and you can clean it with a cotton swab moistened with isopropil alcohol.

--------------------
Maurizio

| IP: Logged

Kenneth Vahrenkamp
Junior
Posts: 6
From: Allen, TX, USA
Registered: Sep 2015

posted September 07, 2015 08:19 PM

Hi
I wondered if those nylon shoe should press the film up to the sound head. Mine do not appear to contact the film at all.

| IP: Logged

Maurizio Di Cintio
Jedi Master Film Handler

Posts: 977
From: Ortona, Italy
Registered: Jan 2004

posted September 08, 2015 09:39 AM

Hi, Kenneth.

Correct, those nylon shoes shoud press against the four gaps on the sound head but only when the main control knob is in soung FWD mode. Otherwise they remain detached from the head for:

a) auto threading
b) silent projection (to spare wear on the heads)

--------------------
Maurizio

| IP: Logged

Kenneth Vahrenkamp
Junior
Posts: 6
From: Allen, TX, USA
Registered: Sep 2015

posted September 08, 2015 12:32 PM

Hi Maurizio
I believe that I am not sure as to where the sound heads are located. The pressers do appear to be in contact with the film when in Fwd. Is there a repair manual or a picture available for download, etc.? This machine has been sitting out of service since 1985 when my son finished high school.

| IP: Logged

Maurizio Di Cintio
Jedi Master Film Handler

Posts: 977
From: Ortona, Italy
Registered: Jan 2004

posted September 08, 2015 12:38 PM

Sound head position: like said, below the lamp housing AND above the sound pressers (which you mentioned so I assume you have located them). I'll try to post some shots later...

--------------------
Maurizio

| IP: Logged

All times are Central

Printer-friendly view of this topic

UBB.classic^TM 6.3.1.2