8mm Forum: Small board from Sankyo 600 that Microswitches attached to and motor wires do too wan

This is topic Small board from Sankyo 600 that Microswitches attached to and motor wires do too wan in forum 8mm equipment for sale/trade at 8mm Forum.

To visit this topic, use this URL:
https://8mmforum.film-tech.com/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=3;t=002516

Posted by Phil Mitchell (Member # 3876) on October 28, 2014, 04:38 AM:

Hi all, rare chance most likely, but one never knows till one asks.

I am after the small power board from a Sankyo 600, (most likely also found in some Titan or other Sankyo machines if they have Micro switches) which sits on top of where Micro Switches are, MS connect to it and on other side the blue and white wires from motor also connect to it, a Green Capacitor has come off, in fact the two on it were very loose.
I suspect they control speed to motor in a ways running without it, motor goes fast so I didn't run it for more than a few seconds.

If no luck finding one, I will get some Caps ( Jaycar here in Aust sell them, Green one labelled 104 which I found out is 100 Nano Farads and replace the two of them, a little bit tricky as there is a resistor right next to hole for one of the Cap.

Refer picture.

Thanks
Phil

UBB.classic^TM 6.3.1.2