posted August 25, 2009 11:49 AM
Hey guys! I'm near finally completing my repair on my Chinon 9500!
After an even closder inspection, I found that the claw and pins were not broken or missing at all. I then noticed, when I held down (gently) the "loop creator" before the film gate, that I got my picture back.
I therefore conclude that the whole problem was that this "loop creator" is mis-aligned. I looked all over and I couldn't find a screw that holds this in place, so I'm curious as to how to do this repiar, but at least I'm pretty close to having my Chinon back up and running!
-------------------- "All these moments will be lost in time, just like ... tears, in the rain. "
Posts: 2110
From: Loganville, Georgia, USA
Registered: Jun 2003
posted August 25, 2009 11:55 PM
Osi, if you could provide some photos that would help. Buy that USB wire and plug it in. You can find them on eBay for a couple of bucks.