Author
|
Topic: Hanimex SR 8600 speed problem
|
|
Dominique De Bast
Film God
Posts: 4486
From: Brussels, Belgium
Registered: Jun 2013
|
posted September 13, 2013 11:44 AM
I haven't this projector so I may not be very helpful but as nobody else has replies, yet...Sometimes, if you're lucky, a problem is resolved by itself. I had my Eumig 932 (after a long time without be used as I have a lot of projectors and, sadly, had to put some of my material in a another place that where I live, so I am slowly bringing it back as I have a little more room) which had the rewind arm not running. I opened the back, just lifted once with a screwdriver the piece that was supposed to move and it was fixed. Then I had the speed (to come back to your question) that was too slow. I just ran the film back, ran the projector empty for one minute, tried again and it was also fixed. I supposed that you checked the voltage. I don't know if a belt can make a projector run faster. If it is that it is easy to fix. I hope it is not an electronic problem.
-------------------- Dominique
| IP: Logged
|
|
|
|
|
|
|
|
|