This is topic Lamp Conversion in forum 8mm Forum at 8mm Forum.

To visit this topic, use this URL:;f=1;t=009740

Posted by Jim Schrader (Member # 9) on February 01, 2015, 12:31 PM:
I just got done converting my tower 8mm projector to a new lamp from the DLS bulb total cost less than 15.00 and the bulbs are cheaper to replace.
I need 2 small screws for the lamp shield, if anybody has one of these units and it does not work or are thinking of tossing it out I could use those I will pay for shipping and if you want to charge me to thats fine, the screws about 4mm doubt that I can find these in the hardware store. tHere is also 1 that holds a cardboard shhield by the fan they aslo have small washers to.
Posted by Dino Everette (Member # 1378) on February 02, 2015, 01:07 AM:
Jim, well done.... Can you get the little screws at Radio Shack or somewhere?
Posted by Jim Schrader (Member # 9) on February 02, 2015, 09:06 AM:
I have not checked at radio shack that is a good idea thanks dino.

Visit for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation