Dear Forum,
I'm currently replacing the belts on a B&H TQ1. However one belt, the toothed long 'timing' one, I have not been able to install. This is because it needs to go over and under a very large capacitor, and as I have no electrical knowledge I'm worried about this element. Normally I leave capacitors well alone but here I have to either remove the 4 screws holding it in place or remove the three wires connecting. As I understand these things hold a powerful charge so natually I don't want to 'have a go!'
I would appreciate any advice, thanks.
I'm currently replacing the belts on a B&H TQ1. However one belt, the toothed long 'timing' one, I have not been able to install. This is because it needs to go over and under a very large capacitor, and as I have no electrical knowledge I'm worried about this element. Normally I leave capacitors well alone but here I have to either remove the 4 screws holding it in place or remove the three wires connecting. As I understand these things hold a powerful charge so natually I don't want to 'have a go!'
I would appreciate any advice, thanks.
Comment