Tweet
I purchased a 535 for 9 bucks at the Goodwill Clearance Center that powered up OK, but the spindles weren't turning in forward or reverse. Upon opening it up, the worm gear looks good, the belts look good, the exciter lamp circuit looks good (unlike my 1550), and the reverse position turns the belts but not the spindle. In the forward position, the belts do not turn. Any suggestions?
- Welcome to the new 8mm Forum! The forum you are looking at is entirely new software. Because there was no good way to import all of the old archived data from the last 20 years on the old software, everyone will need to register for a new account to participate. To access the original forums from 2003-2019 which are now a "read only" status, click on the "FORUM ARCHIVE" link above. Please remember registering with your first and last REAL name is mandatory. This forum is for professionals and fake names are not permitted. To get to the registration page click here. Once the registration has been approved, you will be able to login via the link in the upper right corner of this page. Also, please remember while it is highly encouraged to upload an avatar image to your profile, is not a requirement. If you choose to upload an avatar image, please remember that it IS a requirement that the image must be a clear photo of your face. Thank you!
Comment