Hello I want to know how to test to see if I have power going to the Marc-300 socket pin-holes on my Kalart/Victor 16mm Projector? I have just about all the meters but dont know how to do it? The Projector works fine, sound, film transport, etc. I had three bulbs in stock but none will strike! It was just running fine and now im in the dark. I purchase 2 NOS bulbs on ebay and they are all not working. When I put the ohm meter on the new bulbs they read nothing? So im trying to see if there is power coming out my projector light sockets Pins? My Marc-300 kalart/victor has the Power pack under the Projector not inside. What should I do to figure out what it is....lack of good bulbs or bad Projector?
Steve Singarella
I put a photo below of the Projector bulb Pin-holes...
Steve Singarella
I put a photo below of the Projector bulb Pin-holes...
Comment