Welcome to the new 8mm Forum!
The forum you are looking at is entirely new software. Because there was no good way to import all of the old archived data from the last 20 years on the old software, everyone will need to register for a new account to participate.
To access the original forums from 2003-2019 which are now a "read only" status, click on the "FORUM ARCHIVE" link above.
Please remember registering with your first and last REAL name is mandatory. This forum is for professionals and fake names are not permitted. To get to the registration page click here.
Once the registration has been approved, you will be able to login via the link in the upper right corner of this page.
Also, please remember while it is highly encouraged to upload an avatar image to your profile, is not a requirement. If you choose to upload an avatar image, please remember that it IS a requirement that the image must be a clear photo of your face.
Thank you!
I just bought some 8mm films and I am able to play them, however I cannot figure out how to align the frame correctly with this projector. It is a Movector 8 projector.
Has anyone experience with aligning frames with this projector?
I must admit that I do not know this projector but after looking at a picture of an Agfa Movector 8 there appear to be two possible controls which slide. Such a control would probably move the frame of the gate. There is a lever below the gate and another opposite the gate somewhat in the lamp house. I suspect the latter could be a still device. But you could try each one.
Tweet
Comment