Tweet
Hello, I have just pulled out my Elmo ST180M to use and it appears dead. It was working when it was put away, but probably has not been used for a few years, I tend to use my Eumig 807D. When you connect it up the volume widow with the needle lights up, but when you turn forward or reverse, nothing, not a murmer and the bulb does not illuminate either. Looking inside, one belt is a bit aged, but even so the projector should show some signs of life. Any suggestions?
- Welcome to the new 8mm Forum! The forum you are looking at is entirely new software. Because there was no good way to import all of the old archived data from the last 20 years on the old software, everyone will need to register for a new account to participate. To access the original forums from 2003-2019 which are now a "read only" status, click on the "FORUM ARCHIVE" link above. Please remember registering with your first and last REAL name is mandatory. This forum is for professionals and fake names are not permitted. To get to the registration page click here. Once the registration has been approved, you will be able to login via the link in the upper right corner of this page. Also, please remember while it is highly encouraged to upload an avatar image to your profile, is not a requirement. If you choose to upload an avatar image, please remember that it IS a requirement that the image must be a clear photo of your face. Thank you!
Comment