From Greensboro NC,
Janice was kind to answer my question about an Elmo FP-C, which helped me. I suggest getting an inexpensive voltmeter at Harbor Freight Tools, if you do not have a VM. The wiring to the lamp socket may have been altered by a previous owner. The correct lamp is DCA, 150 W, 21 volts. As measured, the socket voltage should be a bit higher. Open the back case and look at the wiring, if the voltage is not correct. NEVER open the case with the power cord plugged in. Take care and good hunting. Thank you again Janice. David L. Baker (NOT the guy in Florida.)
- Welcome to the new 8mm Forum! The forum you are looking at is entirely new software. Because there was no good way to import all of the old archived data from the last 20 years on the old software, everyone will need to register for a new account to participate. To access the original forums from 2003-2019 which are now a "read only" status, click on the "FORUM ARCHIVE" link above. Please remember registering with your first and last REAL name is mandatory. This forum is for professionals and fake names are not permitted. To get to the registration page click here. Once the registration has been approved, you will be able to login via the link in the upper right corner of this page. Also, please remember while it is highly encouraged to upload an avatar image to your profile, is not a requirement. If you choose to upload an avatar image, please remember that it IS a requirement that the image must be a clear photo of your face. Thank you!
Leave a comment: