8mm Forum


  
my profile | my password | search | faq | register | forum home
  next oldest topic   next newest topic
» 8mm Forum   » 8mm equipment for sale/trade   » Bell & Howell 10MS

- UBBFriend: Email this page to someone!    
Author Topic: Bell & Howell 10MS
Lonnie Boozer
Junior
Posts: 5
From: Columbus, OH. USA
Registered: Sep 2015

- posted September 29, 2015 06:15 PM      Profile for Lonnie Boozer   Email Lonnie Boozer   Send New Private Message       Edit/Delete Post 
Hello, I have a Bell & Howell 10MS and the front pulley is cracked in half I have read that I may be able to pull it off and just clean it and glue it but I would rather just replace it does anyone know where I can get one or the part number for it so I can research where to get it Thanks Lonnie

 |  IP: Logged
Janice Glesser
Film Goddess

Posts: 3468
From: Sunnyvale, CA USA
Registered: Sep 2011

- posted September 29, 2015 10:54 PM      Profile for Janice Glesser     Send New Private Message       Edit/Delete Post 
You'll most likely have to buy another projector for parts...I did. Why don't you try and see if gluing will hold it? Use a strong glue like Elmer's Glue-All Max. However, Elmer's Glue-All Max expands...so use it sparingly. Worth a try.

[ October 01, 2015, 04:31 PM: Message edited by: Janice Glesser ]

--------------------
Janice

"I'm having a very good day!"
Richard Dreyfuss - Let It Ride (1989).

 |  IP: Logged
Barry Fritz
Phenomenal Film Handler

Posts: 1061
From: Burnsville, MN, USA
Registered: Dec 2009

- posted September 30, 2015 07:06 PM      Profile for Barry Fritz   Email Barry Fritz   Send New Private Message       Edit/Delete Post 
Might be a good part for Van Eck to make.

 |  IP: Logged
Lonnie Boozer
Junior
Posts: 5
From: Columbus, OH. USA
Registered: Sep 2015

- posted September 30, 2015 07:43 PM      Profile for Lonnie Boozer   Email Lonnie Boozer   Send New Private Message       Edit/Delete Post 
Do you really think it could be made or simply buy another one for parts but if I do that who knows if that pully would be good or not?

 |  IP: Logged
Barry Fritz
Phenomenal Film Handler

Posts: 1061
From: Burnsville, MN, USA
Registered: Dec 2009

- posted September 30, 2015 08:19 PM      Profile for Barry Fritz   Email Barry Fritz   Send New Private Message       Edit/Delete Post 
Edwin van Eck, who is a member of this forum, has a company that produces hard to find projector parts by using a 3D printer.

 |  IP: Logged


All times are Central  
   Close Topic    Move Topic    Delete Topic    next oldest topic   next newest topic
- Printer-friendly view of this topic
Hop To:

Visit www.film-tech.com for free equipment manual downloads. Copyright 2003-2019 Film-Tech Cinema Systems LLC

Powered by Infopop Corporation
UBB.classicTM 6.3.1.2