8mm Forum: Sankyo Sound 600 projector

»	8mm Forum » General Yak » Sankyo Sound 600 projector

UBBFriend: Email this page to someone!

Author

Topic: Sankyo Sound 600 projector

Angelo Segall
Junior
Posts: 2
From: Montreal, Canada
Registered: Dec 2015

posted December 15, 2015 10:34 AM

During projection my Sankyo Sound 600 went to a full stop. I took off the back cover and verified if the driving belt was on. It was intact, without any signs of tear. Next I remove the belt and turned the unit on. The motor started without problem. Then I tried stopping the motor by holding the pulley simulating a torque - the motor stopped without effort. I conclude that the motor torque is no efficient.
Questions:
1. Has someone encountered a similar problem?
2. Can you please recommend corrective action?
3. Can anyone share/sell a service & repair manual for this projector?
Any help is greatly appreciated.
AGS
Canada

--------------------
AGS

| IP: Logged

Janice Glesser
Film Goddess

Posts: 3468
From: Sunnyvale, CA USA
Registered: Sep 2011

posted December 15, 2015 06:37 PM

Hi Angelo ... My guess is that you have a micro switch that is failing. Check out this thread:

http://8mmforum.film-tech.com/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic;f=1;t=009970

Replacing the micro switches on this machines is doable...but not an easy task.

If you PM me your email address...I can send you a schematic.

--------------------
Janice

"I'm having a very good day!"
Richard Dreyfuss - Let It Ride (1989).

| IP: Logged

Angelo Segall
Junior
Posts: 2
From: Montreal, Canada
Registered: Dec 2015

posted December 15, 2015 07:00 PM

Hi Janice
Thank you for your prompt reply;
Please send me the schematic.
My email address is: Angelo@bell.net

Greatly appreciate your help
Angelo

--------------------
AGS

| IP: Logged

All times are Central

Printer-friendly view of this topic

UBB.classic^TM 6.3.1.2