Tweet
Recently acquired this great projector , it is an early one with tube amp . Can anyone tell me what type/ number the exciter lamp should be? The one running at the moment is fine, but there is nothing I can see to identify it. It has a horizontal filament and smooth brass base with no pins or flange, just an indentation where the securing screw tightens onto it. Thanks!
-
-
-
Thanks Mark, great pic, mine is in lovely condition, it runs on 110volts,fortunately I bought an old B/H tranny at Farnworth a couple of years ago ,it was only a fiver, good job I bought it. A quick electrical check New cables and hey presto does the job.
I just love the earlier projectors, the build quality( and weight) was so much better than some of the later models ,also they look the business!Comment
-
John
Can you describe what the exciter lamp looks like, are there no markings at all? Or better still, post a photo.
MauriceComment
-
Maurice, looks like a standard size lamp , cannot see any markings at all. Will try and send pic, be patient as I am new to this forum. Thanks for your interest ,JohnComment
-
John it most likely uses a BSK 6v 1.0 amps.Comment
-
[QUOTE It has a horizontal filament and smooth brass base with no pins or flange[/QUOTE]
As John says above, his lamp has no pins or flange, so the suggested BKS (G40) with its skirt seems an unlikely replacement.
https://www.ebay.co.uk/itm/G40-BSK-6...-/171712901067
MauriceComment
Comment