Welcome to the new 8mm Forum!
The forum you are looking at is entirely new software. Because there was no good way to import all of the old archived data from the last 20 years on the old software, everyone will need to register for a new account to participate.
To access the original forums from 2003-2019 which are now a "read only" status, click on the "FORUM ARCHIVE" link above.
Please remember registering with your first and last REAL name is mandatory. This forum is for professionals and fake names are not permitted. To get to the registration page click here.
Once the registration has been approved, you will be able to login via the link in the upper right corner of this page.
Also, please remember while it is highly encouraged to upload an avatar image to your profile, is not a requirement. If you choose to upload an avatar image, please remember that it IS a requirement that the image must be a clear photo of your face.
Thank you!
Hi Michael, the screw on my B&H spindles is METRIC, size M2.5 x 6, and needs a washer 5mm x 2.5mm to work. I bought my replacements at a company that handles special fasteners, here in Greensboro NC. I have replaced nearly all of the plastic screws in my several 8mm and super 8mm projectors, design 245, 253, 353, 456, et al. Some B&H projectors have metal screws for the reel spindle; however, I am not sure when the change happened. I hope this information is helpful. David L. Baker Greensboro NC
The plastic screw on my take-up spindle broke and I need to get a new screw. can anyone tell me the correct thread size for this?
I'm leaning towards #4-48 as a 4-40 screw is close but won't go.
Leave a comment: