Stan, I will need to reference my files. Looks like I didn't file everything where they should be. If you are referring to the dimensions of the descending part, I just measured it at 13x13 mm.
This was the process. Rather than check the printer for calibration, I just printed the part. I measured the mask margins in IC Measure and added or subtracted as much to align the left and right margins. I would check for movement of the part in place, and estimated how much to adjust it. I was always adding until it snapped in and could still be easily removed. This made the margin adjustments more accurate.
This mask can be left in place. It will not fall out even it the gate is opened. I will add a Reg8 version. In that case where it will be changed out, it would be useful to have the handle that Kamel's version has.
In the end I tested my printer by printing a 100mm cube. The printed cube measured 100mm!
This was the process. Rather than check the printer for calibration, I just printed the part. I measured the mask margins in IC Measure and added or subtracted as much to align the left and right margins. I would check for movement of the part in place, and estimated how much to adjust it. I was always adding until it snapped in and could still be easily removed. This made the margin adjustments more accurate.
This mask can be left in place. It will not fall out even it the gate is opened. I will add a Reg8 version. In that case where it will be changed out, it would be useful to have the handle that Kamel's version has.
In the end I tested my printer by printing a 100mm cube. The printed cube measured 100mm!
Comment